UCP212-39HT BLT

The TRITAN UCP HT (High Temperature) series standard duty Pillow Block ball bearing unit features a cast iron housing and a ball bearing insert with silicon flinger seals and set screw lock. The housing is made of cast iron for rigidity and vibration damping, and has a solid base for mounting stability. The double-sealed, deep-groove ball bearing insert is made of through-hardened heat stabilized chromium steel, with an expanded internal (C4) radial clearance and is appropriate for applications with moderate radial loads and light thrust or combination loads. It has a wide inner ring on both sides for increased shaft support and reduced inner-ring tilt for smooth operation. The insert bearing has a sphered outer surface that allows it to self-align within the housing & compensate for misalignments. It also has an anti-rotation pin in outer surface that prevents the bearings from spinning within the housing and ensures smooth performance. Steel-reinforced high temperature Silicon lip seals with flingers on both sides of the bearing retain the high temperature multi-purpose lubricant and deflect contaminants away from the seals. ~~ The bearing locks onto the shaft with two set screws spaced 120 degrees apart for a three-point contact hold. Set screw locking is suitable for low to moderate speed applications where the shaft rotates in a single or reversing direction. The unit is equipped with a grease fitting on the housing’s outer surface for reapplying lubricant, and the insert bearing has a groove and oil hole in the outer ring to efficiently channel grease into the bearing during re-lubrication. ~~ High Temperature Ball Bearing Pillow Block units are especially suitable for use in industrial and commercial applications where temperature exceed 250 F degrees. ~~ TRITAN manufactures high quality bearings and power transmission components such as roller chain, sprockets, bushings, and pulleys (sheaves) in ISO certified factories that comply with AFMBA, ISO & ANSI standards for quality assurance.