UC210-32HT BLT

The TRITAN UC series insert bearings are double-sealed deep-groove ball bearings made of through-hardened chromium steel and are appropriate for applications with moderate radial loads and light thrust or combination loads. They have a wide inner ring on both sides for increased shaft support and reduced inner-ring tilt for smooth operation. The bearing has a sphered outer surface that allows it to self-align within the housing & compensate for misalignments. It also has an anti-rotation pin in the outer surface that prevents the bearing from free spinning within the housing and ensures smooth performance. ~~ These special (HT) inserts are designed for High-Temperature applications. They incorporate steel-reinforced molded Silicon seals with flingers on both sides of the bearing to retain the high temperature lubricant and deflect contaminants away from the seals. The bearings rings are heat stabilized and produced with a C4/C5 radial internal clearance to allow for thermal expansion. ~~ The bearing locks onto the shaft with two cup point setscrews spaced 120 degrees apart for a three-point contact hold. The area around the set screw is specially annealed to prevent cracking when set screws are tightened. Set screw locking is suitable for low to moderate speed applications where the shaft rotates in a single or reversing direction. ~~ These Insert bearings are designed for use in pillow block or flange units, made to AFBMA standards, interchangeable, and can be used in housings produced by most manufacturers. ~~ TRITAN manufactures high quality bearings and power transmission components such as roller chain, sprockets, bushings & pulleys (sheaves) in ISO certified factories that comply with AFMBA, ISO & ANSI standards for quality assurance.